The parts that fail first in San Antonio are the ones the water reaches.
Commercial boiler parts are sold over the counter at the San Antonio branch on Randolph Boulevard, will-call during business hours. The mix on that shelf leans toward the water side, because at around 21 grains per gallon scale reaches things on a schedule you can almost predict.
Heat exchangers foul. Relief and safety valves seat badly once there is enough deposit on them. Circulating pumps work against restriction they were never sized for. None of those are exotic failures, but in this market they come around faster than the maintenance interval a manufacturer wrote for average water.

That changes what a counter is for. If you are buying the same part for the same unit a second time, the part is not the problem, and the useful conversation is about what is in front of the boiler rather than what is on the shelf.
It is the same reason the branch sells commercial water softeners alongside the parts. One of the two stops you coming back.
Across the boiler room, not just the boiler.
The categories below are stocked across the Willbanks network. What the San Antonio counter does not have on the shelf comes off the Missouri City one.
Burner and combustion.
Burners, ignitors, flame sensors, platform ignition modules, and manifolds. The parts that strand a unit when combustion will not prove.
Controls and safeties.
Control panels, safety valves, air and gas pressure switches, gas regulators, and CO monitors. The things an inspector looks at and a high limit trips through.
Hydronic and circulation.
Circulating, inline, and booster pumps, blowdown valves, and heat exchanger replacements and repairs. The category San Antonio water drives hardest.
Venting, tanks, and the rest.
Flue gas dampers, vent connectors, breaching, draft hoods, storage and expansion tanks, gauges, thermometers, and gaskets.
Call the counter, or send a photograph.
Most of the delay in a parts order is identifying the part, not shipping it. Both of the first two steps are yours.
- 01Photograph the nameplate.Make, model, and serial off the data plate settles in one picture what a description takes three calls to narrow down.
- 02Call Randolph Boulevard.210-509-7638 reaches the San Antonio branch. Counter staff who work on this equipment, rather than a catalogue search.
- 03Pick it up, or have it sent.Will-call if you are passing, and off the network shelf if the counter does not have it. We will tell you which it is on the call rather than after.
- 04Ask why it failed.Worth thirty seconds. A part that has failed twice on the same unit is a symptom, and on this water it usually points at treatment.
Parts & equipment in San Antonio.
- Yes. The San Antonio branch at 6035 Randolph Blvd runs a will-call counter during business hours, as every Willbanks branch does. Call 210-509-7638 before you drive over and we will confirm the part is on the shelf.
- No. We sell to mechanical contractors, building owners, and in-house maintenance teams alike. Willbanks is commercial and industrial only, so what we will not do is supply a residential system.
- It comes off the network shelf. Missouri City is our primary distribution center and carries over 2,500 line items, and the branches move stock between them. The counter will tell you on the call which shelf your part is sitting on.
- Often, yes. Our equipment sales side represents specific manufacturers, including Raypak, Riello, Fulton, Weil-McLain, and Webster, but the parts and service side works across the brands that are actually installed in Texas buildings.
- On San Antonio water that is usually scale rather than a bad part. At around 21 grains per gallon, deposit builds on heat exchangers, valve seats, and pump internals fast enough to shorten the life of the replacement too. Treatment in front of the unit is what breaks the cycle.
The rest of what the branch does.
Everything below runs out of 6035 Randolph Blvd, with the same techs and the same inventory.






