In San Antonio, the fault usually starts in the water, not at the burner.
Most commercial boilers we open in San Antonio, steam and hot water alike, are failing for a reason that started on the water side rather than at the burner. At around 21 grains per gallon the water deposits scale quickly, and scale is an insulator: a scaled tube cannot move heat into the water it is supposed to be heating.
What you see is a burner problem. Stack temperature climbs. The high limit starts tripping. Somebody resets it, the unit runs a few hours, and it drops out again. The symptom is at the burner. The cause is upstream of it.

One of the first questions on a San Antonio service call is about the water rather than the part: whether there is treatment in front of the unit, what the hardness actually reads at that address, and when the boiler was last cleaned.
That matters commercially as well as technically. Replacing a control on a boiler that is scaling up buys a few weeks rather than a fix, which is why we diagnose before we quote parts.
Commercial and industrial. Any brand.
Our equipment sales side represents specific manufacturers. Our service side is brand agnostic, and has been for decades.
Emergency response, 24/7/365.
A real person in Texas answers the phone, including at 2am on a holiday weekend. Dispatch runs out of the San Antonio branch on Randolph Boulevard.
Troubleshooting and combustion analysis.
Our techs are troubleshooters first. Combustion gets tuned to the equipment and the application rather than left where the last person set it.
Controls, safeties, and leaks.
High limit trips, flame failures, low water cutoffs, failed valves and igniters, and the leaks that show up once a unit has been running scaled for a season.
Parts on the shelf.
Over 2,500 parts in inventory across the Willbanks network, so a common failure does not turn into a two week wait for a part to ship.
From the phone call to a cause.
The goal of a service call is not to leave a part behind. It is to leave you knowing why the boiler did what it did.
- 01You call. A person picks up.No phone tree to get through before you reach somebody who knows what a low water cutoff is.
- 02Send photographs.The fastest thing you can do to speed us up is let us see the unit, the nameplate, and the fault code before the truck is loaded.
- 03A tech is dispatched with parts.Knowing the equipment in advance means the common failure parts for that unit come on the truck rather than on a second trip.
- 04You get the diagnosis, not just the invoice.If the cause is water, controls, or an installation that was wrong from the start, we tell you that, and we tell you what it takes to fix it properly.
Boiler repair in San Antonio.
- Yes. On the service side Willbanks is brand agnostic and will work on commercial boilers from any manufacturer. The manufacturer alignment applies to our equipment sales business, not to who we will service.
- Yes. Emergency dispatch runs 24/7/365 out of the San Antonio branch at 6035 Randolph Blvd. Call 210-509-7638, or (833) 9-BOILER for the statewide line.
- No. Willbanks works on commercial and industrial equipment only. For a home system you want a residential plumbing or HVAC contractor.
- It is a signal that something should be looked at either way. Whether it ends up being a repair or a replacement depends on what caused it, and our service calls are built to make that decision on facts and evidence rather than on a guess.
- The San Antonio metro, the I-10 corridor, and the Hill Country, out of the branch on Randolph Boulevard on the northeast side. That takes in the corridor towns outside the city as well, including New Braunfels, San Marcos, and Kyle.
The rest of what the branch does.
Everything below runs out of 6035 Randolph Blvd, with the same techs and the same inventory.






